Home › Engine / Hybrid System › 2TR-FE ENGINE CONTROL › SFI SYSTEM(w/ Secondary Air Injection System) › 2011.10–2012.04
RM1840EF _51 Engine / Hybrid System _009569 2TR-FE ENGINE CONTROL _0052076 SFI SYSTEM(w/ Secondary Air Injection System) C

2TR-FE ENGINE CONTROL  SFI SYSTEM(w/ Secondary Air Injection System)  P060D  Internal Control Module Accelerator Pedal Position Performance  


DESCRIPTION

The ECM monitors the input signals of the accelerator pedal position sensor No. 1. When the input signals and control signals deviate, a DTC is stored.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
P060D Internal Control Module Accelerator Pedal Position Performance Either condition is met (1 trip detection logic):
·

There is an ECM main CPU error.

·

There is an ECM sub CPU error.


ECM Comes on DTC stored

MONITOR STRATEGY

Required sensors/Components ECM
Frequency of operation Once per driving cycle

TYPICAL MALFUNCTION THRESHOLDS

Difference of main accelerator pedal position and sub accelerator pedal position 0.3 V or more

CONFIRMATION DRIVING PATTERN

1.

Turn the ignition switch off.

2.

Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.

3.

Connect the cable to the negative (-) battery terminal.

4.

Turn the ignition switch to ON and wait for 16 seconds or more.


PROCEDURE

1.CHECK FOR DTC
a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the intelligent tester on.


d.

e.

Turn the intelligent tester off.


f.

Turn the ignition switch off.


g.

Disconnect the intelligent tester.


h.

Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.


i.

Connect the cable to the negative (-) battery terminal.


j.

Connect the intelligent tester to the DLC3.


k.

Turn the ignition switch to ON and turn the intelligent tester on.


l.

Wait 16 seconds or more.


m.

Enter the following menus: Powertrain / Engine and ECT / DTC.

Powertrain > Engine > Trouble Codes
50001 61

n.

Check for DTCs.

OK:

P060D is not output.



Result:
Proceed to
OK
NG



OK

NG