Home › Engine / Hybrid System › 2TR-FE ENGINE CONTROL › THROTTLE BODY › 2011.10–2013.10
RM1840EF _51 Engine / Hybrid System _009569 2TR-FE ENGINE CONTROL _0052079 THROTTLE BODY A

2TR-FE ENGINE CONTROL  THROTTLE BODY  INSTALLATION  


PROCEDURE

Hide 1.INSTALL THROTTLE BODY WITH MOTOR ASSEMBLY

a.
A102440
2.208,1.635 2.667,1.906 2.667,1.906 2.75,1.906 false 1.969,0.771 2.646,0.094 2.646,0.094 2.74,0.094 false 2.813,1.813 3.021,2 0.208,0.188 10 *2 2.781,0.021 3.094,0.281 0.313,0.26 10 *1
*1 Protrusion
*2 Groove


Install a new gasket to the intake manifold.

HINT:

Align the protrusion of the gasket with the groove of the intake manifold.



b.

Install the throttle body with motor assembly with the 2 bolts and 2 nuts.

Torque:
9.0 N*m (92 kgf*cm, 80 in.*lbf)


c.

Connect the 2 water by-pass hoses to the throttle body with motor assembly.


d.

Connect the throttle position sensor and control motor connector.


Hide 2.INSTALL INTAKE AIR CONNECTOR

a.

Install the intake air connector with the 2 bolts, and then tighten the 2 hose clamps.

Torque:
for bolt : 8.0 N*m (82 kgf*cm, 71 in.*lbf)
for hose clamp on throttle body side : 5.0 N*m (51 kgf*cm, 44 in.*lbf)
for hose clamp on air cleaner side : 4.0 N*m (41 kgf*cm, 35 in.*lbf)


b.

Connect the No. 2 PCV hose.


c.

Connect the vacuum hose.


Hide 4.PERFORM INITIALIZATION

NOTICE:

Perform the following procedure after replacing or removing and installing the ECM, throttle body or any throttle body components or after reconnecting the battery cable. The following procedure should also be performed if the throttle body is cleaned.


a.

Disconnect the EFI and ETCS fuses at the same time. Wait at least 60 seconds and reconnect the fuses.


b.

Turn the ignition switch to ON without operating the accelerator pedal.

NOTICE:

If the accelerator pedal is operated, perform the above steps again.




d.

Start the engine and check that the MIL is not illuminated and that the idle speed is within the specified range when the cooler is switched off after the engine is warmed up.

Engine Idle Speed:
Condition Specified Condition
Air conditioning switched off 600 to 700 rpm


NOTICE:
·

Be sure to perform this step with all accessories off.

·

Make sure that the shift lever is in neutral.




e.

Enter the following menus: Powertrain / Engine and ECT / Data List / Throttle Sensor Position. Fully depress the accelerator pedal and check that the value is 60% or more.

Powertrain > Engine > Data List
Tester Display
Throttle Sensor Position
50003 61 72

f.

Perform a road test and confirm that there are no abnormalities.