Home › Engine / Hybrid System › 2TR-FE ENGINE CONTROL › ACCELERATOR PEDAL
RM1840EF _51 Engine / Hybrid System _009569 2TR-FE ENGINE CONTROL _0052081 ACCELERATOR PEDAL A

2TR-FE ENGINE CONTROL  ACCELERATOR PEDAL  INSTALLATION  


PROCEDURE

Hide 1.INSTALL ACCELERATOR PEDAL ROD ASSEMBLY

NOTICE:
·

Prevent physical shocks to the accelerator pedal rod assembly.

·

Do not disassemble the accelerator pedal rod assembly.

·

This accelerator pedal does not require lubrication.

Do not apply oil or other lubrication to the accelerator pedal rod assembly.

If applied, the accelerator pedal rod assembly must be replaced.



a.

Install the accelerator pedal rod assembly with the 2 bolts.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


b.

Connect the accelerator pedal position sensor connector.