Home › Engine / Hybrid System › 2TR-FE ENGINE CONTROL › ACCELERATOR PEDAL
RM1840EF _51 Engine / Hybrid System _009569 2TR-FE ENGINE CONTROL _0052081 ACCELERATOR PEDAL G

2TR-FE ENGINE CONTROL  ACCELERATOR PEDAL  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT ACCELERATOR PEDAL ROD ASSEMBLY

a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the intelligent tester on.


d.

Enter the following menus: Powertrain / Engine and ECT / Data List/ Accel Sensor Out No. 1, Accel Sensor Out No. 2.

Powertrain > Engine > Data List
Tester Display
Accel Sensor Out No.1
Accel Sensor Out No.2
50003 61 412,413

e.

When depressing or releasing the accelerator pedal, check that the values of Accel Sensor Out No. 1 and Accel Sensor Out No. 2 are within the specification.

Standard Voltage:
Item Condition Specified Condition
Accel Sensor Out No. 1 Released 0.5 to 1.1 V
Depressed 2.6 to 4.5 V
Accel Sensor Out No. 2 Released 1.2 to 2.0 V
Depressed 3.4 to 5.0 V


If the result is not as specified, check the accelerator pedal rod assembly, wire harness and ECM.