Perform the mass air flow meter inspection in accordance with the procedure below.
Only replace the mass air flow meter when foreign matter adheres to the sensor and both MAF values in the Data List (with the engine stopped) are not within the normal operating range.
1.CHECK MASS AIR FLOW METER
Read the values using the intelligent tester (MAF).
Perform the inspection with the vehicle indoors and on a level surface.
Perform the inspection of the mass air flow meter while it is installed to the air cleaner case (installed to the vehicle).
During the test, do not use an exhaust air duct on the exhaust pipe.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON (do not run the engine).
Turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / Data List / MAF.
| Tester Display |
|---|
| MAF |
Wait 30 seconds, and then read the values on the intelligent tester.
| Tester Display | Condition | Specified Condition |
|---|---|---|
| MAF | ·
Engine not running ·
30 seconds after ignition switch turned to ON |
Less than 0.36 g/sec |
If the result is not as specified, replace the mass air flow meter.
If the result is within the specified range, remove and inspect the mass air flow meter (See page Engine / Hybrid System>2TR-FE ENGINE CONTROL>MASS AIR FLOW METER>INSPECTION).