Home › Engine / Hybrid System › 2TR-FE ENGINE CONTROL › HEATED OXYGEN SENSOR(w/o Secondary Air Injection System)
RM1840EF _51 Engine / Hybrid System _009569 2TR-FE ENGINE CONTROL _0052090 HEATED OXYGEN SENSOR(w/o Secondary Air Injection System) G

2TR-FE ENGINE CONTROL  HEATED OXYGEN SENSOR(w/o Secondary Air Injection System)  INSPECTION  


PROCEDURE

Hide 1.INSPECT HEATED OXYGEN SENSOR (for Bank 1 Sensor 1)

a.

Check the resistance.

i.
A112088
1.281,0.802 0.792,0.802 true 2.615,0.813 2.063,0.813 true 0.573,0.719 0.865,0.917 0.292,0.198 10 false +B 2.677,0.719 3.177,0.927 0.5,0.208 10 false HT1A 0.094,0.073 0.271,0.24 0.177,0.167 10 false *a
*a Component without harness connected
(Heated Oxygen Sensor)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (HT1A) - 2 (+B) 20°C (68°F) 5 to 10 Ω


If the result is not as specified, replace the heated oxygen sensor.