Home › Engine / Hybrid System › 1KD-FTV ENGINE CONTROL › ACCELERATOR PEDAL
RM1840EF _51 Engine / Hybrid System _009570 1KD-FTV ENGINE CONTROL _0052098 ACCELERATOR PEDAL A

1KD-FTV ENGINE CONTROL  ACCELERATOR PEDAL  INSTALLATION  


PROCEDURE

Hide 1.INSTALL ACCELERATOR PEDAL SENSOR ASSEMBLY

NOTICE:
·

Avoid excessive force to the accelerator pedal sensor.

·

Do not disassemble the accelerator pedal sensor assembly.

·

This accelerator pedal does not require lubrication.

Do not apply oil or lubricant to the accelerator pedal sensor assembly.

If applied, the accelerator pedal sensor assembly must be replaced.



a.

Install the accelerator pedal sensor with the 2 bolts.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


b.

Connect the accelerator pedal sensor connector.