Home › Engine / Hybrid System › 1KD-FTV ENGINE CONTROL › INTAKE AIR TEMPERATURE SENSOR(w/o Glow Plug Controller)
RM1840EF _51 Engine / Hybrid System _009570 1KD-FTV ENGINE CONTROL _0052100 INTAKE AIR TEMPERATURE SENSOR(w/o Glow Plug Controller) A

1KD-FTV ENGINE CONTROL  INTAKE AIR TEMPERATURE SENSOR(w/o Glow Plug Controller)  REMOVAL  


PROCEDURE

Hide 2.REMOVE INTAKE AIR TEMPERATURE SENSOR

a.

Disconnect the intake air temperature sensor connector.

A260798
0.083,0.031 0.552,0.198 0.469,0.167 10 *A 3.74,0.042 4.24,0.219 0.5,0.177 10 *B
*A w/ EGR Cooler *B w/o EGR Cooler



b.

Using a 22 mm deep socket wrench, remove the intake air temperature sensor.

HINT:

Replace the intake air temperature sensor if it is deformed, cracked or malfunctioning. It is not necessary to replace the intake air temperature sensor each time the intercooler is replaced.