To detect atmospheric pressure, the built-in atmospheric pressure sensor in the ECM is used. Using the atmospheric pressure, the ECM corrects the injection volume, timing and duration, and adjusts the common rail internal fuel pressure in order to optimize engine combustion.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| P2226 | Barometric Pressure Circuit | Atmospheric pressure sensor voltage is 1.4 V or less, or 4.0 V or higher for 0.5 seconds (1 trip detection logic). | ECM | Comes on | DTC stored |
| P2228 | Barometric Pressure Circuit Low Input | Atmospheric pressure sensor voltage is 1.4 V or less for 0.5 seconds (1 trip detection logic). | ECM | Comes on | DTC stored |
| P2229 | Barometric Pressure Circuit High Input | Atmospheric pressure sensor voltage is 4.0 V or higher for 0.5 seconds (1 trip detection logic). | ECM | Comes on | DTC stored |
| DTC No. | Data List |
|---|---|
| P2226 | ·
Atmosphere Pressure ·
MAP |
| P2228 | |
| P2229 |
When the ignition switch to ON, the intake manifold pressure, "MAP", is approximately equal to atmospheric pressure.
Under standard atmospheric pressure conditions, the output of the atmospheric pressure sensor is 101 kPa. For every 100 m increase in elevation, pressure drops by 1 kPa. This varies by weather (high atmospheric pressure, low atmospheric pressure).
If DTC P2226, P2228 and/or P2229 is stored, the following symptoms may appear:
Misfire
Combustion noise
Black smoke
White smoke
| DTC Detection Drive Pattern | Ignition switch to ON for 1 second |
After replacing the ECM, the new ECM needs registration (See page Engine / Hybrid System>1KD-FTV ENGINE CONTROL>ECD SYSTEM(w/o EGR Cooler)>REGISTRATION) and initialization (See page Engine / Hybrid System>1KD-FTV ENGINE CONTROL>ECD SYSTEM(w/o EGR Cooler)>INITIALIZATION).
Replace the ECM
Click hereEngine / Hybrid System>1KD-FTV ENGINE CONTROL>ECM>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Clear the DTCs.
Click hereEngine / Hybrid System>1KD-FTV ENGINE CONTROL>ECD SYSTEM(w/o EGR Cooler)>DTC CHECK / CLEAR
Turn the ignition switch to ON and wait for 1 second or more.
Confirm that the DTC is not output again.
| Proceed to |
|---|
| NEXT |
NEXT