Home › Engine / Hybrid System › 1KD-FTV ENGINE CONTROL › ECD SYSTEM(w/o EGR Cooler) › 2012.04–2012.10
RM1840EF _51 Engine / Hybrid System _009570 1KD-FTV ENGINE CONTROL _0052103 ECD SYSTEM(w/o EGR Cooler) D

1KD-FTV ENGINE CONTROL  ECD SYSTEM(w/o EGR Cooler)  CHECK FOR INTERMITTENT PROBLEMS  


HINT:

Intelligent tester only:


Inspect the vehicle ECM using check mode. Intermittent problems are easier to detect with the intelligent tester when the ECM is in check mode. In check mode, the ECM uses 1 trip detection logic, which is more sensitive to malfunctions than normal mode (default), which uses 2 trip detection logic.

2.

Switch the ECM from normal mode to check mode using the intelligent tester (See page Engine / Hybrid System>1KD-FTV ENGINE CONTROL>ECD SYSTEM(w/o EGR Cooler)>CHECK MODE PROCEDURE).

3.

Perform a simulation test.

4.

Check and wiggle the harness(es), connector(s) and terminal(s).