FAIL-SAFE CHART
If any of the following DTCs are stored, the ECM enters fail-safe mode to allow the vehicle to be driven temporarily.
| DTC No. | Detection Item | Fail-safe Operation | Fail-safe Deactivation Condition |
|---|---|---|---|
| P0046 | Turbocharger / Supercharger Boost Control Solenoid Circuit Range / Performance | The engine power is limited. | Ignition switch off |
| P0047 | Turbocharger / Supercharger Boost Control "A" Circuit Low | The engine power is limited. | Ignition switch off |
| P0048 | Turbocharger / Supercharger Boost Control "A" Circuit High | The engine power is limited. | Ignition switch off |
| P007C | Charge Air Cooler Temperature Sensor Circuit Low | The intake air temperature is fixed at a specified value. | Pass condition detected |
| P007D | Charge Air Cooler Temperature Sensor Circuit High | The intake air temperature is fixed at a specified value. | Pass condition detected |
| P0088 | Fuel Rail / System Pressure - Too High | The engine power is reduced by 90%.* | Ignition switch off |
| P0093 | Fuel System Leak Detected - Large Leak | The engine power is limited. | Ignition switch off |
| P0100 | Mass Air Flow Circuit Malfunction | The engine power is limited. | Pass condition detected |
| P0107 | Manifold Absolute Pressure / Barometric Pressure Circuit Low Input | The turbo pressure is fixed at a specified value. | Pass condition detected |
| P0108 | Manifold Absolute Pressure / Barometric Pressure Circuit High Input | The turbo pressure is fixed at a specified value. | Pass condition detected |
| P0112 | Intake Air Temperature Circuit Low Input | The intake air temperature value is fixed. | Pass condition detected |
| P0113 | Intake Air Temperature Circuit High Input | The intake air temperature value is fixed. | Pass condition detected |
| P0115 | Engine Coolant Temperature Circuit | The engine coolant temperature sensor output is fixed at a specified value (the fixed value varies depending on conditions). | Pass condition detected |
| P0117 | Engine Coolant Temperature Circuit Low Input | The engine coolant temperature sensor output is fixed at a specified value (the fixed value varies depending on conditions). | Pass condition detected |
| P0118 | Engine Coolant Temperature Circuit High Input | The engine coolant temperature sensor output is fixed at a specified value (the fixed value varies depending on conditions). | Pass condition detected |
| P0122 | Throttle / Pedal Position Sensor / Switch "A" Circuit Low Input | The engine power is limited. | Ignition switch off |
| P0123 | Throttle / Pedal Position Sensor / Switch "A" Circuit High Input | The engine power is limited. | Ignition switch off |
| P0201 | Injector Circuit / Open - (Cylinder 1) | The engine power is limited. | Ignition switch off to ON or STA on |
| P0202 | Injector Circuit / Open - (Cylinder 2) | The engine power is limited. | Ignition switch off to ON or STA on |
| P0203 | Injector Circuit / Open - (Cylinder 3) | The engine power is limited. | Ignition switch off to ON or STA on |
| P0204 | Injector Circuit / Open - (Cylinder 4) | The engine power is limited. | Ignition switch off to ON or STA on |
| P0299 | Turbocharger / Supercharger Underboost | The engine power is limited. | Pass condition detected |
| P029D | Cylinder 1 - Injector Leaking | The engine power is limited. | Ignition switch off |
| P02A1 | Cylinder 2 - Injector Leaking | The engine power is limited. | Ignition switch off |
| P02A5 | Cylinder 3 - Injector Leaking | The engine power is limited. | Ignition switch off |
| P02A9 | Cylinder 4 - Injector Leaking | The engine power is limited. | Ignition switch off |
| P0335 | Crankshaft Position Sensor "A" Circuit | The engine power is reduced by 90%.* | Pass condition detected |
| P0339 | Crankshaft Position Sensor "A" Circuit Intermittent | The engine power is reduced by 90%.* | Pass condition detected |
| P0340 | Camshaft Position Sensor "A" Circuit (Bank 1 or Single Sensor) | The engine power is reduced by 90%.* | Pass condition detected |
| P0405 | Exhaust Gas Recirculation Sensor "A" Circuit Low | The engine power is limited. | Ignition switch off |
| P0406 | Exhaust Gas Recirculation Sensor "A" Circuit High | The engine power is limited. | Ignition switch off |
| P042E | Exhaust Gas Recirculation "A" Control Stuck Open | The engine power is limited. | Ignition switch off |
| P0488 | Exhaust Gas Recirculation Throttle Position Control Range / Performance | The engine power is limited. | Ignition switch off |
| P0489 | Exhaust Gas Recirculation Control Circuit Low | The engine power is limited. | Ignition switch off |
| P0490 | Exhaust Gas Recirculation Control Circuit High | The engine power is limited. | Ignition switch off |
| P0500 | Vehicle Speed Sensor "A" | The vehicle speed is fixed at 0 km/h (0 mph). | Pass condition detected |
| P0606 | ECM / PCM Processor | The engine power is reduced by 90%.* | Pass condition detected |
| P060A | Internal Control Module Monitoring Processor Performance | The engine power is reduced by 90%.* | Pass condition detected |
| P060B | Internal Control Module A/D Processing Performance | The engine power is reduced by 90%.* | Pass condition detected |
| P0627 | Fuel Pump Control Circuit / Open | The engine power is limited. | Pass condition detected |
| P062D | No. 1 Fuel Injector Driver Circuit Performance | The engine is stalled. | Ignition switch off |
| P1229 | Fuel Pump System | The engine power is limited. | Ignition switch off |
| P1251 | Turbocharger / Supercharger Overboost Condition (Too High) | The engine power is limited. | Ignition switch off |
| P1271 | Fuel Regulator Circuit Malfunction (EDU Drive) | The engine power is limited. | Ignition switch off |
| P1272 | Fuel Pressure Regulator Malfunction | The engine power is limited. | Ignition switch off |
| P13A1 | Fuel Pressure Sensor Circuit Low #1(Sub CPU) | ·
The engine power is reduced by 90% when sensor #1 and #4 are both malfunctioning. ·
The engine power is limited when sensor #1, #2 and #3 are malfunctioning. ·
The engine power is limited when sensor #2, #3 and #4 are malfunctioning. |
Ignition switch off |
| P13A2 | Fuel Pressure Sensor Circuit High #1(Sub CPU) | ||
| P13A6 | Fuel Pressure Sensor Circuit Low #2(Sub CPU) | ||
| P13A7 | Fuel Pressure Sensor Circuit High #2(Sub CPU) | ||
| P13AB | Fuel Pressure Sensor Circuit Low #3(Sub CPU) | ||
| P13AC | Fuel Pressure Sensor Circuit High #3(Sub CPU) | ||
| P13B1 | Fuel Pressure Sensor Circuit Low #4(Sub CPU) | ||
| P13B2 | Fuel Pressure Sensor Circuit High #4(Sub CPU) | ||
| P13A3 | Fuel Pressure Sensor Circuit Range/Performance #1 | ·
The engine power is reduced by 90% when sensor #1 and #4 are both malfunctioning. ·
The engine power is limited when sensor #1, #2 and #3 are malfunctioning. ·
The engine power is limited when sensor #2, #3 and #4 are malfunctioning. |
Battery cable disconnected or DTCs cleared |
| P13A8 | Fuel Pressure Sensor Circuit Range/Performance #2 | ||
| P13AD | Fuel Pressure Sensor Circuit Range/Performance #3 | ||
| P13B3 | Fuel Pressure Sensor Circuit Range/Performance #4 | ||
| P13C1 | Fuel Temperature Sensor Circuit Low #1 | The fuel temperature is fixed at 50°C (122°F) when there are 3 or more cylinders with malfunctioning fuel temperature sensors. | Ignition switch off |
| P13C2 | Fuel Temperature Sensor Circuit High #1 | ||
| P13C6 | Fuel Temperature Sensor Circuit Low #2 | ||
| P13C7 | Fuel Temperature Sensor Circuit High #2 | ||
| P13CB | Fuel Temperature Sensor Circuit Low #3 | ||
| P13CC | Fuel Temperature Sensor Circuit High #3 | ||
| P13D1 | Fuel Temperature Sensor Circuit Low #4 | ||
| P13D2 | Fuel Temperature Sensor Circuit High #4 | ||
| P13E1 | Fuel Pressure Sensor Circuit Low #1(Main CPU) | The engine power is reduced by 90% when sensor #1 and #4 are both malfunctioning. | Ignition switch off |
| P13E6 | Fuel Pressure Sensor Circuit Low #4(Main CPU) | ||
| P13E2 | Fuel Pressure Sensor Circuit High #1(Main CPU) | ||
| P13E7 | Fuel Pressure Sensor Circuit High #4(Main CPU) | ||
| P1626 | Idle Signal Output Value Too Low | The engine power is limited. | Ignition switch off |
| P1627 | Idle Signal Output Value Too High | The engine power is limited. | Ignition switch off |
| P167A | Lost Communication with Injector #1 | The fuel temperature is fixed at 50°C (122°F). | Ignition switch off |
| P167B | Lost Communication with Injector #2 | The fuel temperature is fixed at 50°C (122°F). | Ignition switch off |
| P167C | Lost Communication with Injector #3 | The fuel temperature is fixed at 50°C (122°F). | Ignition switch off |
| P167D | Lost Communication with Injector #4 | The fuel temperature is fixed at 50°C (122°F). | Ignition switch off |
| P168A | Injector #1 Internal EEPROM Malfunction | ·
The engine power is reduced by 90% when injector #1 and #4 are both malfunctioning. ·
The engine power is limited when injector #1, #2 and #3 are malfunctioning. ·
The engine power is limited when injector #2, #3 and #4 are malfunctioning. |
Ignition switch off |
| P168B | Injector #2 Internal EEPROM Malfunction | ||
| P168C | Injector #3 Internal EEPROM Malfunction | ||
| P168D | Injector #4 Internal EEPROM Malfunction | ||
| P2006 | Intake Manifold Runner Control Stuck Closed (Bank 1) | The engine power is limited. | Ignition switch off |
| P2120 | Throttle / Pedal Position Sensor / Switch "D" Circuit | The engine power is limited. | Ignition switch off |
| P2121 | Throttle / Pedal Position Sensor / Switch "D" Circuit Range / Performance | The engine power is limited. | Ignition switch off |
| P2122 | Throttle / Pedal Position Sensor / Switch "D" Circuit Low Input | The engine power is limited. | Ignition switch off |
| P2123 | Throttle / Pedal Position Sensor / Switch "D" Circuit High Input | The engine power is limited. | Ignition switch off |
| P2125 | Throttle / Pedal Position Sensor / Switch "E" Circuit | The engine power is limited. | Ignition switch off |
| P2127 | Throttle / Pedal Position Sensor / Switch "E" Circuit Low Input | The engine power is limited. | Ignition switch off |
| P2128 | Throttle / Pedal Position Sensor / Switch "E" Circuit High Input | The engine power is limited. | Ignition switch off |
| P2138 | Throttle / Pedal Position Sensor / Switch "D"/"E" Voltage Correlation | The engine power is limited. | Ignition switch off |
| P2226 | Barometric Pressure Circuit | The atmospheric pressure is fixed at a specified value. | Pass condition detected |
| P2228 | Barometric Pressure Circuit Low Input | The atmospheric pressure is fixed at a specified value. | Pass condition detected |
| P2229 | Barometric Pressure Circuit High Input | The atmospheric pressure is fixed at a specified value. | Pass condition detected |
| P2564 | Turbocharger / Supercharger Boost Control Position Sensor "A" Circuit Low | The engine power is limited. | Ignition switch off |
| P2565 | Turbocharger / Supercharger Boost Control Position Sensor "A" Circuit High | The engine power is limited. | Ignition switch off |
*: Engine power is limited immediately after the DTC is stored.