Home › Engine / Hybrid System › 2TR-FBE ENGINE CONTROL › CAMSHAFT OIL CONTROL VALVE
RM1840EF _51 Engine / Hybrid System _009571 2TR-FBE ENGINE CONTROL _0052112 CAMSHAFT OIL CONTROL VALVE G

2TR-FBE ENGINE CONTROL  CAMSHAFT OIL CONTROL VALVE  INSPECTION  


PROCEDURE

Hide 1.INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 6.9 to 7.9 Ω


If the result is not as specified, replace the camshaft timing oil control valve assembly.


b.
A123787
2.469,0.208 2.625,0.208 2.625,0.208 2.781,0.625 true 2.906,0.625 2.99,0.208 2.99,0.208 3.125,0.208 true 2.365,0.125 2.51,0.333 0.146,0.208 10 false 1 3.188,0.115 3.302,0.302 0.115,0.188 10 false 2 0.115,0.063 0.396,0.302 0.281,0.24 10 false *a
*a Component without harness connected
(Camshaft Timing Oil Control Valve)


Connect the positive (+) lead of the battery to terminal 1 and the negative (-) lead to terminal 2 and check the movement of the valve.

OK:
Tester Connection Condition Specified Condition
1 - 2 Battery positive (+) voltage is applied Valve moves in direction of left arrow shown in illustration
Battery positive (+) voltage is cut off Valve moves in direction of right arrow shown in illustration


If the result is not as specified, replace the oil control valve assembly.

If the valve cannot return properly because of foreign matter, a small pressure leak in the advanced direction may occur and a DTC may be stored.