Home › Engine / Hybrid System › 2TR-FBE ENGINE CONTROL › THROTTLE BODY
RM1840EF _51 Engine / Hybrid System _009571 2TR-FBE ENGINE CONTROL _0052113 THROTTLE BODY G

2TR-FBE ENGINE CONTROL  THROTTLE BODY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.CHECK THROTTLE BODY WITH MOTOR ASSEMBLY

a.

Check the throttle control motor operating sound.

i.

Turn the ignition switch to ON.


ii.

When depressing the accelerator pedal, check the operating sound of the running motor. Make sure that no friction noises are emitted from the motor. If friction noise exists, replace the throttle body.



b.

Check the throttle position sensor.

i.

Connect the intelligent tester to the DLC3.


ii.

Turn the ignition switch to ON.


iii.

Turn the intelligent tester on.


iv.

Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / Throttle Sensor Position.

Powertrain > Engine and ECT > Data List
Tester Display
Throttle Sensor Position
50003 234 12
Standard throttle valve opening percentage:

60% or more


NOTICE:

When checking the standard throttle valve opening percentage, make sure the transmission is in neutral.


If the result is not as specified, check the throttle body with motor, the wire harness and the ECM.