Home › Engine / Hybrid System › 2TR-FBE ENGINE CONTROL › ACCELERATOR PEDAL
RM1840EF _51 Engine / Hybrid System _009571 2TR-FBE ENGINE CONTROL _0052115 ACCELERATOR PEDAL A

2TR-FBE ENGINE CONTROL  ACCELERATOR PEDAL  INSTALLATION  


PROCEDURE

Hide 1.INSTALL ACCELERATOR PEDAL ROD ASSEMBLY

NOTICE:

This accelerator pedal does not require lubrication.

Do not apply oil or other lubrication to the accelerator pedal rod assembly.

If applied, the accelerator pedal rod assembly must be replaced.


a.

Install the accelerator pedal rod with the 2 bolts.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


b.

Connect the accelerator pedal position sensor connector.