Home › Engine / Hybrid System › 2TR-FBE ENGINE CONTROL › ACCELERATOR PEDAL
RM1840EF _51 Engine / Hybrid System _009571 2TR-FBE ENGINE CONTROL _0052115 ACCELERATOR PEDAL G

2TR-FBE ENGINE CONTROL  ACCELERATOR PEDAL  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT ACCELERATOR PEDAL ROD ASSEMBLY

a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the intelligent tester on.


d.

Enter the following menus: Powertrain / Engine and ECT / Data List / ETCS / Accel Sensor Out No. 1 and Accel Sensor Out No. 2.

Powertrain > Engine and ECT > Data List
Tester Display
Accel Sensor Out No.1
Accel Sensor Out No.2
50003 234 280,281

e.

Read the value displayed on the intelligent tester.

Standard Voltage:
Accelerator Pedal Operation Accel Sensor Out No. 1 Accel Sensor Out No. 2
Released 0.5 to 1.1 V 1.2 to 2.0 V
Depressed 2.6 to 4.5 V 3.4 to 5.0 V


If the result is not as specified, check the accelerator pedal, wire harness and ECM.