Home › Engine / Hybrid System › 2TR-FBE ENGINE CONTROL › MASS AIR FLOW METER
RM1840EF _51 Engine / Hybrid System _009571 2TR-FBE ENGINE CONTROL _0052116 MASS AIR FLOW METER G

2TR-FBE ENGINE CONTROL  MASS AIR FLOW METER  INSPECTION  


PROCEDURE

Hide 1.INSPECT MASS AIR FLOW METER

a.
A162734
0.927,2.5 1.125,1.833 true 0.792,1.521 0.927,2.5 true 0.813,2.542 1.042,2.719 0.229,0.177 10 false *1
*1 Platinum Hot Wire
(Heater)


Perform a visual check for any foreign matter on the platinum hot wire (heater) of the mass air flow meter shown in the illustration.

OK:

There is no foreign material.


If the result is not as specified, replace the mass air flow meter.


b.
A173003
1.49,1.344 1.49,1.771 true 0.906,1.771 0.906,1.698 0.906,1.698 1.25,1.333 true 1.26,1.198 1.396,1.375 0.135,0.177 10 false 5 2.073,1.198 2.188,1.375 0.115,0.177 10 false 1 1.885,1.198 2,1.375 0.115,0.177 10 false 2 1.677,1.198 1.792,1.375 0.115,0.177 10 false 3 1.458,1.198 1.573,1.375 0.115,0.177 10 false 4 0.052,0 0.25,0.188 0.198,0.188 10 false *a 1.333,1.802 1.688,1.969 0.354,0.167 10 false THA 0.802,1.802 1.031,1.979 0.229,0.177 10 false E2
*a Component without harness connected
(Mass Air Flow Meter)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
4 (THA) - 5 (E2) -20°C (-4°F) 13.6 to 18.4 kΩ
20°C (68°F) 2.21 to 2.69 kΩ
60°C (140°F) 0.493 to 0.667 kΩ


If the result is not as specified, replace the mass air flow meter.