Home › Engine / Hybrid System › 2TR-FBE ENGINE CONTROL › CAMSHAFT POSITION SENSOR
RM1840EF _51 Engine / Hybrid System _009571 2TR-FBE ENGINE CONTROL _0052117 CAMSHAFT POSITION SENSOR A

2TR-FBE ENGINE CONTROL  CAMSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 1.INSTALL CAMSHAFT POSITION SENSOR

a.

Apply a light coat of engine oil to the O-ring of the sensor.


b.

Install the sensor with the bolt.

Torque:
8.5 N*m (87 kgf*cm, 75 in.*lbf)

NOTICE:

Make sure that the O-ring is not cracked or jammed when installing.



c.

Connect the sensor connector.