Home › Engine / Hybrid System › 2TR-FBE ENGINE CONTROL › KNOCK SENSOR › from 2012.10
RM1840EF _51 Engine / Hybrid System _009571 2TR-FBE ENGINE CONTROL _0052121 KNOCK SENSOR A

2TR-FBE ENGINE CONTROL  KNOCK SENSOR  INSTALLATION  


PROCEDURE

Hide 1.INSTALL KNOCK SENSOR

a.
A099415
1.146,0.125 1.344,0.313 0.198,0.188 10 *a 0.375,0.99 0.552,1.167 0.177,0.177 10 *b 3.021,0.844 3.365,1.021 0.344,0.177 10 10° 3.021,1.156 3.365,1.333 0.344,0.177 10 10°
*a Upper
*b Front


Install the sensor so that it is horizontal as shown in the illustration. Then install the bolt.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)

NOTICE:

The acceptable installation angle of the sensor is between 10° upward and downward from the horizontal position.



b.

Connect the sensor connector.