Home › Engine / Hybrid System › 2TR-FBE ENGINE CONTROL › HEATED OXYGEN SENSOR
RM1840EF _51 Engine / Hybrid System _009571 2TR-FBE ENGINE CONTROL _0052122 HEATED OXYGEN SENSOR A

2TR-FBE ENGINE CONTROL  HEATED OXYGEN SENSOR  INSTALLATION  


PROCEDURE

Hide 1.INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)

a.
A194933
2.979,2.323 2.875,2.323 2.875,2.323 2.635,0.813 true 3.031,2.229 3.427,2.427 0.396,0.198 10 false SST 1.552,1.771 1.802,1.969 0.25,0.198 10 false *1
*1 Fulcrum Length


Using SST, install the heated oxygen sensor.

SST
09224-00010  

Torque:
for use without SST : 44 N*m (449 kgf*cm, 32 ft.*lbf)
for use with SST : 40 N*m (408 kgf*cm, 30 ft.*lbf)

HINT:
·

Use a torque wrench with a fulcrum length of 300 mm (11.8 in.). When using a torque wrench with a fulcrum length that is not 300 mm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

Make sure SST and the wrench are connected in a straight line.




b.

Connect the heated oxygen sensor connector.