Home › Engine / Hybrid System › 2TR-FBE ENGINE CONTROL › POWER STEERING OIL PRESSURE SWITCH
RM1840EF _51 Engine / Hybrid System _009571 2TR-FBE ENGINE CONTROL _0052123 POWER STEERING OIL PRESSURE SWITCH G

2TR-FBE ENGINE CONTROL  POWER STEERING OIL PRESSURE SWITCH  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT POWER STEERING OIL PRESSURE SWITCH

a.

Check the oil pressure switch.

i.

Connect the intelligent tester to the DLC3.


ii.

Turn the ignition switch to ON.


iii.

Turn the intelligent tester on.


iv.

Enter the following menus: Powertrain / Engine and ECT / Data List / Power Steering Signal.

Powertrain > Engine and ECT > Data List
Tester Display
Power Steering Signal
50003 234 116

v.

Start the engine.


vi.

Read the value displayed on the tester.

OK:
Condition Specified Condition
Power steering operating ON
Power steering not operating OFF


If the result is not as specified, check the wire harness and connector. If the wire harness and connector are normal, replace the power steering oil pressure switch.