INITIALIZATION
Perform initialization (throttle position) after replacing the throttle body with motor assembly or cleaning any throttle body with motor assembly components (See page Engine / Hybrid System>2TR-FBE ENGINE CONTROL>THROTTLE BODY>INSTALLATION).
Perform initialization (throttle position) after reconnecting the battery cable or replacing the ECM (See page Engine / Hybrid System>2TR-FBE ENGINE CONTROL>THROTTLE BODY>INSTALLATION).
If the ECM is replaced, register the ECM communication ID for the immobiliser system (refer to the Service Bulletin for Registration).
Perform Registration (VIN registration) when replacing the ECM (See page Engine / Hybrid System>2TR-FBE ENGINE CONTROL>SFI SYSTEM>REGISTRATION).