While the engine is being cranked, current flows from terminal ST1 of the ignition switch to the park/neutral position switch (for automatic transmission) or clutch start switch (for manual transmission) and also flows to terminal STA of the ECM (STA Signal).
Refer to DTC P0617 (See page Engine / Hybrid System>2TR-FBE ENGINE CONTROL>SFI SYSTEM>P0617).
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
This chart is based on the premise that the engine can be cranked normally. If the engine does not crank normally, proceed to Problem Symptoms Table (See page Engine / Hybrid System>2TR-FBE ENGINE CONTROL>SFI SYSTEM>PROBLEM SYMPTOMS TABLE).
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / Data List / Starter Signal.
| Tester Display |
|---|
| Starter Signal |
Read the value displayed on the tester when the ignition switch is ON and when the engine is started.
| Ignition Switch Position | Starter Signal |
|---|---|
| ON | Close |
| START | Open |
| Result | Proceed to |
|---|---|
| OK | A |
| NG (for Manual transmission) | B |
| NG (for Automatic transmission) | C |
A
B
C
Disconnect the ECM connector.
Disconnect the ignition switch assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G146-8 (STA) - G9-7 (ST2) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G146-8 (STA) or G9-7 (ST2) - Body ground | Always | 10 kΩ or higher |
Reconnect the ECM connector.
Reconnect the ignition switch assembly connector.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the ECM connector.
Disconnect the park/neutral position switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G146-8 (STA) - C26-5 | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G146-8 (STA) or C26-5 - Body ground | Always | 10 kΩ or higher |
Reconnect the ECM connector.
Reconnect the park/neutral position switch connector.
| Proceed to |
|---|
| OK |
| NG |
OK
NG