Home › Engine / Hybrid System › 2TR-FBE ENGINE CONTROL › SFI SYSTEM › 2011.10–2012.10
RM1840EF _51 Engine / Hybrid System _009571 2TR-FBE ENGINE CONTROL _0052126 SFI SYSTEM C

2TR-FBE ENGINE CONTROL  SFI SYSTEM  P0604  Internal Control Module Random Access Memory (RAM) Error  P0606  ECM / PCM Processor  P060A  Internal Control Module Monitoring Processor Performance  P060B  Internal Control Module A/D Processing Performance  P060D  Internal Control Module Accelerator Pedal Position Performance  P060E  Internal Control Module Throttle Position Performance  P0657  Actuator Supply Voltage Circuit / Open  


DESCRIPTION

The ECM continuously monitors its internal memory status, internal circuits and output signals transmitted to the throttle actuator. This self-check ensures that the ECM is functioning properly. If any malfunction is detected, the ECM stores the appropriate DTC and illuminates the MIL.

The ECM memory status is diagnosed by internal "mirroring" of the main CPU and sub CPU to detect Random Access Memory (RAM) errors. The 2 CPUs also perform continuous mutual monitoring. The ECM illuminates the MIL and stores a DTC if: 1) outputs from the 2 CPUs are different or deviate from the standard, 2) the signals sent to the throttle actuator deviate from the standard, 3) a malfunction is detected in the throttle actuator supply voltage, or 4) any other ECM malfunction is detected.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
P0604 Internal Control Module Random Access Memory (RAM) Error ECM internal error (1 trip detection logic). ECM Comes on DTC stored
P0606 ECM / PCM Processor ECM internal error (1 trip detection logic). ECM Comes on DTC stored
P060A Internal Control Module Monitoring Processor Performance ECM internal error (1 trip detection logic). ECM Comes on DTC stored
P060B Internal Control Module A/D Processing Performance ECM internal error (1 trip detection logic). ECM Comes on DTC stored
P060D Internal Control Module Accelerator Pedal Position Performance ECM internal error (1 trip detection logic). ECM Comes on DTC stored
P060E Internal Control Module Throttle Position Performance ECM internal error (1 trip detection logic). ECM Comes on DTC stored
P0657 Actuator Supply Voltage Circuit / Open ECM internal error (1 trip detection logic). ECM Comes on DTC stored

CAUTION / NOTICE / HINT

HINT:

Read freeze frame data using the intelligent tester. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air fuel ratio was lean or rich, and other data from the time the malfunction occurred.


PROCEDURE

1.CHECK WHETHER DTC OUTPUT RECURS
a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the tester on.


d.

Enter the following menus: Powertrain / Engine and ECT / DTC.

Powertrain > Engine and ECT > Trouble Codes
50001 234

e.

Read the DTCs.


Result:
Result Proceed to
DTC P0604, P0606, P060A, P060B, P060D, P060E and/or P0657 is output A
DTC is not output B



A

B