Home › Engine / Hybrid System › 2TR-FBE ENGINE CONTROL › SFI SYSTEM › 2011.10–2012.10
RM1840EF _51 Engine / Hybrid System _009571 2TR-FBE ENGINE CONTROL _0052126 SFI SYSTEM D

2TR-FBE ENGINE CONTROL  SFI SYSTEM  DTC CHECK / CLEAR  


NOTICE:

All the stored DTCs and freeze frame data are cleared if: 1) the ECM is changed from normal mode to check mode or vice versa; or 2) the ignition switch is turned from ON to ACC or off while in check mode. Before changing modes, always check and make a note of any DTCs and freeze frame data.


HINT:
·

DTCs which are stored in the ECM can be output to the intelligent tester. The intelligent tester can display both current and pending DTCs.

·

Malfunctions that were not detected a second time by the ECM during the second driving cycle are stored as pending DTCs.



CHECK FOR DTC


a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON and turn the tester on.


c.

Enter the following menus: Powertrain / Engine and ECT / DTC.

Powertrain > Engine and ECT > Trouble Codes
50001 234

d.

Check the DTCs and freeze frame data, and then write them down.




CLEAR DTC


a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON and turn the tester on.


c.

Enter the following menus: Powertrain / Engine and ECT / DTC / Clear.

Powertrain > Engine and ECT > Clear DTCs
50002 234

d.

Press the YES button.



CLEAR DTC (Without using intelligent tester)


a.

Perform either of the following operations:

i.

Disconnect the cable from the negative (-) battery terminal for more than 1 minute.


ii.

Remove the EFI and ETCS fuses from the engine room relay block (located inside the engine compartment) for more than 1 minute.