Home › Engine / Hybrid System › 2TR-FBE ENGINE CONTROL › SFI SYSTEM › from 2012.10
RM1840EF _51 Engine / Hybrid System _009571 2TR-FBE ENGINE CONTROL _0052126 SFI SYSTEM D

2TR-FBE ENGINE CONTROL  SFI SYSTEM  CHECK FOR INTERMITTENT PROBLEMS  


HINT:

Inspect the ECM using check mode. Intermittent problems are easier to detect with the intelligent tester when the ECM is in check mode. In check mode, the ECM uses 1-trip detection logic, which is more sensitive to malfunctions than normal mode (default), which uses 2-trip detection logic.

2.

Switch the ECM from normal mode to check mode using the intelligent tester (See page Engine / Hybrid System>2TR-FBE ENGINE CONTROL>SFI SYSTEM>CHECK MODE PROCEDURE).

3.

Perform a simulation test.

4.

Check and wiggle the harness(es), connector(s) and terminal(s).