DTC P0630 is stored when the Vehicle Identification Number (VIN) is not stored in the ECM, or the input VIN is incorrect. The VIN is input with the intelligent tester.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| P0630 | VIN not Programmed or Mismatch - ECM / PCM | Either condition is met (1 trip detection logic):
·
VIN is not stored in the ECM. ·
Input VIN is incorrect. |
ECM | Comes on | DTC stored |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read DTCs.
| Result | Proceed to |
|---|---|
| DTC P0630 is output | A |
| DTC P0630 and other DTCs are output | B |
If any DTCs other than P0630 are output, troubleshoot those DTCs first.
If P0630 is stored, the VIN must be input to the ECM using the intelligent tester. However, all DTCs are cleared automatically by the intelligent tester when the VIN is input. If DTCs other than P0630 are output, troubleshoot them first.
A
B
Refer to Registration.
Click hereEngine / Hybrid System>2TR-FBE ENGINE CONTROL>SFI SYSTEM>REGISTRATION
| Proceed to |
|---|
| NEXT |
NEXT