Home › Engine / Hybrid System › 1GR-FE ENGINE CONTROL › THROTTLE BODY › from 2012.10
RM1840EF _51 Engine / Hybrid System _009572 1GR-FE ENGINE CONTROL _0052130 THROTTLE BODY A

1GR-FE ENGINE CONTROL  THROTTLE BODY  INSTALLATION  


PROCEDURE

Hide 1.INSTALL THROTTLE BODY WITH MOTOR ASSEMBLY

a.

Install a new gasket to the intake air surge tank.


b.

Install the throttle body with motor assembly with the 4 bolts.

Torque:
11 N*m (112 kgf*cm, 8 ft.*lbf)


c.

Connect the throttle body with motor connector.


d.

Connect the No. 4 and No. 5 water by-pass hoses.


Hide 2.INSTALL AIR CLEANER ASSEMBLY

a.

Install the air cleaner with the 2 bolts.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


b.

Tighten the 2 hose clamps.


c.

Attach the 2 wire harness clamps.


d.

Connect the mass air flow meter connector.


e.

Connect the vacuum hose.


Hide 3.CONNECT NO. 2 PCV HOSE

a.

Connect the No. 2 PCV hose and clamp.


Hide 4.INSTALL V-BANK COVER

a.

Install the V-bank cover with the 2 nuts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


Hide 7.PERFORM INITIALIZATION

NOTICE:
·

Be sure to perform this procedure after reassembling the throttle body or removing and reinstalling any throttle body component.

·

Perform the following procedure after replacing the ECM, throttle body or any throttle body components. The following procedure should also be performed if the throttle body is cleaned.

·

Be sure to perform this procedure after replacing the ECM and reconnecting the battery cable.



a.

Disconnect the EFI and ETCS fuses at the same time. Wait at least 60 seconds, and then reconnect the fuses.


b.

Turn the ignition switch to ON without operating the accelerator pedal.

NOTICE:

If the accelerator pedal is operated, perform the above steps again.



c.

Connect the GTS to the DLC3 and clear the DTCs (See page Engine / Hybrid System>1GR-FE ENGINE CONTROL>SFI SYSTEM>DTC CHECK / CLEAR).


d.

Start the engine and check that the MIL is not illuminated and that the idle speed is within the specified range when the A/C is switched off after the engine is warmed up.

Standard idle speed:

650 to 750 rpm


NOTICE:
·

Be sure to perform this step with all accessories off.

·

Make sure that the shift lever is in neutral.




e.

Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / Throttle Sensor Position. Fully depress the accelerator pedal and check that the value is 60% or more.

Powertrain > Engine > Data List
Tester Display
Throttle Sensor Position
50003 61 72

f.

Perform a road test and confirm that there are no abnormalities.