1.DRAIN ENGINE COOLANT
2.REMOVE V-BANK COVER
Remove the 2 nuts and V-bank cover.
3.DISCONNECT NO. 2 PCV HOSE
Disconnect the clamp and No. 2 PCV hose.
4.REMOVE AIR CLEANER ASSEMBLY
Disconnect the vacuum hose.
Disconnect the mass air flow meter connector.
Detach the 2 wire harness clamps.
Loosen the 2 hose clamps.
Remove the 2 bolts and air cleaner.
5.REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY
Disconnect the No. 4 and No. 5 water by-pass hoses.
Disconnect the throttle body with motor connector.
Remove the 4 bolts and throttle body with motor assembly.
Remove the gasket from the intake air surge tank.