Home › Engine / Hybrid System › 1GR-FE ENGINE CONTROL › ECM › 2012.04–2012.10
RM1840EF _51 Engine / Hybrid System _009572 1GR-FE ENGINE CONTROL _0052131 ECM A

1GR-FE ENGINE CONTROL  ECM  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 4.REMOVE 4 WHEEL DRIVE CONTROL ECU

a.

Disconnect the connector.


b.
A252940

Remove the bolt and 4 wheel drive control ECU.


Hide 5.REMOVE ECM

a.

Disconnect the 5 ECM connectors.


b.
A252941

Remove the bolt, 2 nuts and ECM.


Hide 6.REMOVE NO. 1 ECM BRACKET

a.
A252942

Remove the 3 screws and No. 1 ECM bracket.


Hide 7.REMOVE NO. 2 ECM BRACKET

a.
A252943

Remove the 2 screws and No. 2 ECM bracket.