Home › Engine / Hybrid System › 1GR-FE ENGINE CONTROL › ACCELERATOR PEDAL › from 2012.04
RM1840EF _51 Engine / Hybrid System _009572 1GR-FE ENGINE CONTROL _0052132 ACCELERATOR PEDAL A

1GR-FE ENGINE CONTROL  ACCELERATOR PEDAL  INSTALLATION  


PROCEDURE

Hide 1.INSTALL ACCELERATOR PEDAL ROD ASSEMBLY

NOTICE:
·

Avoid physical shocks to the accelerator pedal rod assembly.

·

Do not disassemble the accelerator pedal rod assembly.

·

This accelerator pedal does not require lubrication.

Do not apply oil or other lubrication to the accelerator pedal rod assembly.

If applied, the accelerator pedal rod assembly must be replaced.



a.

Install the accelerator pedal rod with the 2 bolts.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


b.

Connect the accelerator pedal rod connector.