Home › Engine / Hybrid System › 1GR-FE ENGINE CONTROL › CRANKSHAFT POSITION SENSOR › from 2012.10
RM1840EF _51 Engine / Hybrid System _009572 1GR-FE ENGINE CONTROL _0052135 CRANKSHAFT POSITION SENSOR A

1GR-FE ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 1.INSTALL CRANK POSITION SENSOR

a.

Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.

NOTICE:
·

When reusing the crankshaft position sensor, inspect the O-ring.

·

If the O-ring has scratches or cuts, replace the crankshaft position sensor.




b.

Install the crankshaft position sensor with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


c.

Connect the crankshaft position sensor connector.


Hide 2.CONNECT COOLER COMPRESSOR ASSEMBLY

a.
A112978
2.042,1.042 2.26,0.667 2.26,0.667 2.604,0.667 true 2.458,0.146 2.583,0.313 0.125,0.167 10 true 2 1.844,1.76 1.979,1.938 0.135,0.177 10 true 3 1.438,0.292 1.573,0.458 0.135,0.167 10 true 4 2.667,0.552 2.844,0.74 0.177,0.188 10 true A 1.49,0.854 1.604,1.01 0.115,0.156 10 true 1

Temporarily install the compressor with the bolt labeled A.


b.

Install the compressor completely by tightening the 4 bolts in the order shown in the illustration.

Torque:
25 N*m (250 kgf*cm, 18 ft.*lbf)

NOTICE:

In order to prevent misalignment, which causes belt rattle, tightening of the bolts must be performed in the order shown.



c.

Connect the compressor connector.


d.

Connect the suction hose with the 2 bolts.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)