Home › Engine / Hybrid System › 1GR-FE ENGINE CONTROL › AIR FUEL RATIO SENSOR › from 2012.04
RM1840EF _51 Engine / Hybrid System _009572 1GR-FE ENGINE CONTROL _0052139 AIR FUEL RATIO SENSOR G

1GR-FE ENGINE CONTROL  AIR FUEL RATIO SENSOR  INSPECTION  


PROCEDURE

Hide 1.INSPECT AIR FUEL RATIO SENSOR

a.
A226559
1.438,0.917 0.979,0.375 0.979,0.375 0.844,0.375 true 1.969,0.885 2.313,0.198 2.313,0.198 2.448,0.198 true 0.906,1.031 1.063,1.031 1.063,1.031 1.448,1.24 true 2.49,0.083 3.094,0.271 0.604,0.188 10 false HA1A*A 0.563,0.26 0.781,0.458 0.219,0.198 10 false +B 0.042,0.021 0.281,0.292 0.24,0.271 10 false *a 2.49,0.271 3.094,0.458 0.604,0.188 10 false HA2A*B 0.375,0.958 0.854,1.135 0.479,0.177 10 false A1A-*A 0.385,1.146 0.885,1.333 0.5,0.188 10 false A2A-*B
*A for Bank 1
*B for Bank 2
*a Component without harness connected
(Air Fuel Ratio Sensor)


Measure the heater resistance according to the value(s) in the table below.

Standard Resistance (for Bank 1):
Tester Connection Condition Specified Condition
1 (HA1A) - 2 (+B) 20°C (68°F) 1.8 to 3.4 Ω
1 (HA1A) - 4 (A1A-) Always 10 kΩ or higher


Standard Resistance (for Bank 2):
Tester Connection Condition Specified Condition
1 (HA2A) - 2 (+B) 20°C (68°F) 1.8 to 3.4 Ω
1 (HA2A) - 4 (A2A-) Always 10 kΩ or higher


If the result is not as specified, replace the air fuel ratio sensor.