Home › Engine / Hybrid System › 1GR-FE ENGINE CONTROL › POWER STEERING OIL PRESSURE SWITCH › from 2012.04
RM1840EF _51 Engine / Hybrid System _009572 1GR-FE ENGINE CONTROL _0052141 POWER STEERING OIL PRESSURE SWITCH A

1GR-FE ENGINE CONTROL  POWER STEERING OIL PRESSURE SWITCH  INSTALLATION  


PROCEDURE

Hide 1.INSTALL POWER STEERING OIL PRESSURE SWITCH

a.

Install a new O-ring to the power steering oil pressure switch.


b.

Apply a light coat of engine oil to the O-ring of the power steering oil pressure switch.


c.

Using a 24 mm deep socket wrench, install the power steering oil pressure switch.

Torque:
21 N*m (210 kgf*cm, 15 ft.*lbf)

NOTICE:
·

Do not allow foreign matter to contact the oil seal face of the power steering oil pressure switch (surface which contacts the pressure feed tube).

·

Be careful not to damage the O-ring when installing the power steering oil pressure switch.




d.

Connect the power steering oil pressure switch connector.


Hide 2.ADD POWER STEERING FLUID

Hide 3.INSPECT FOR POWER STEERING FLUID LEAK