Home › Engine / Hybrid System › 1KD-FTV ENGINE MECHANICAL › DRIVE BELT
RM1840EF _51 Engine / Hybrid System _009573 1KD-FTV ENGINE MECHANICAL _0052144 DRIVE BELT A

1KD-FTV ENGINE MECHANICAL  DRIVE BELT  INSTALLATION  


PROCEDURE

Hide 1.INSTALL FAN AND GENERATOR V BELT

a.

Rotate the V-ribbed belt tensioner pulley clockwise, and then install the fan and generator V belt.

NOTICE:

Make sure that the fan and generator V belt is set properly on each pulley.



b.

Check that the indicator mark of the V-ribbed belt tensioner (See page Engine / Hybrid System>1KD-FTV ENGINE MECHANICAL>DRIVE BELT>ON-VEHICLE INSPECTION).