1.BORE CYLINDER
Bore all 4 cylinders for the O/S piston outside diameter.
Replace all the piston rings with ones to match the O/S pistons.
Prepare 4 new O/S pistons.
| Item | Specified Condition |
|---|---|
| O/S 0.50 | 96.42 to 96.45 mm (3.796 to 3.797 in.) |
| O/S 0.75 | 96.67 to 96.70 mm (3.806 to 3.807 in.) |
| O/S 1.00 | 96.92 to 96.95 mm (3.816 to 3.817 in.) |
| *1 | Size Mark |
| *2 | Piston Pin Hole Inside Diameter Mark |
| *3 | Front Mark (Arrow) |
| *4 | Distance |
Using a micrometer, measure the piston diameter according to the following conditions: 1) measure at a right angle to the piston center line, and 2) measure at the indicated distance from the piston head.
63 mm (2.48 in.)
Calculate how much each cylinder needs to be rebored.
Size to be rebored = P + C - H
P = Piston diameter
C = Piston clearance: 0.07 to 0.09 mm (0.00276 to 0.00354 in.)
H = Allowance for honing: 0.02 mm (0.000787 in.) or less
Bore and hone the cylinders to the calculated dimensions.
0.02 mm (0.000787 in.)
Excess honing will destroy the finished roundness.