1.REMOVE NO. 1 ENGINE UNDER COVER
2.DRAIN ENGINE COOLANT
3.REMOVE RADIATOR HOSE INLET
4.REMOVE FAN SHROUD
5.REMOVE NO. 1 TIMING BELT COVER
Remove the 6 bolts, 6 washers and timing belt cover.
6.REMOVE TIMING BELT
| *1 | Timing Mark |
Turn the crankshaft clockwise and align the timing marks as shown in the illustration.
If reusing the timing belt, place matchmarks on the timing belt so that it can be installed exactly as before.
Uniformly loosen and remove the 2 bolts and No. 1 timing belt tensioner.
Remove the timing belt.
If turning the camshaft while the timing belt is removed, turn the crankshaft 90° counterclockwise as shown in the illustration.
When installing the timing belt, turn the camshaft to align the timing marks, and then turn the crankshaft clockwise to align the timing marks.
7.REMOVE NO. 1 TIMING BELT IDLER SUB-ASSEMBLY
When inspecting the No. 1 timing belt idler, do not remove it unless absolutely necessary.
Using a 10 mm hexagon wrench, remove the bolt, No. 1 timing belt idler and washer.