Home › Engine / Hybrid System › 1KD-FTV ENGINE MECHANICAL › CYLINDER BLOCK(w/ Glow Plug Controller) › from 2012.04
RM1840EF _51 Engine / Hybrid System _009573 1KD-FTV ENGINE MECHANICAL _0052162 CYLINDER BLOCK(w/ Glow Plug Controller) A

1KD-FTV ENGINE MECHANICAL  CYLINDER BLOCK(w/ Glow Plug Controller)  REPAIR  


PROCEDURE

Hide 1.BORE CYLINDER

HINT:
·

Bore all 4 cylinders for the O/S piston outside diameter.

·

Replace all the piston rings with ones to match the O/S pistons.



a.

Prepare 4 new O/S pistons.

Standard Piston Diameter:
Item Specified Condition
O/S 0.50 96.42 to 96.45 mm (3.796 to 3.797 in.)
O/S 0.75 96.67 to 96.70 mm (3.806 to 3.807 in.)
O/S 1.00 96.92 to 96.95 mm (3.816 to 3.817 in.)



b.
A226797
2.073,1.104 1.635,0.573 1.635,0.573 1.531,0.573 false 2.302,1.188 2.708,0.573 2.708,0.573 2.802,0.573 true 1.552,1.406 1.552,2.479 true 1.469,2.531 1.667,2.708 0.198,0.177 10 false *3 2.708,2.042 2.896,2.219 0.188,0.177 10 false *4 1.323,0.469 1.49,0.646 0.167,0.177 10 false *1 2.823,0.469 3.042,0.635 0.219,0.167 10 false *2
*1 Size Mark
*2 Piston Pin Hole Inside Diameter Mark
*3 Front Mark (Arrow)
*4 Distance


Using a micrometer, measure the piston diameter according to the following conditions: 1) measure at a right angle to the piston center line, and 2) measure at the indicated distance from the piston head.

Distance:

63.5 mm (2.50 in.)



c.

Calculate how much each cylinder needs to be rebored:

Size to be rebored:

Size to be rebored = P + C - H

P = Piston diameter

C = Piston clearance: 0.07 to 0.09 mm (0.00276 to 0.00354 in.)

H = Allowance for honing: 0.02 mm (0.000787 in.) or less



d.

Bore and hone the cylinders to the calculated dimensions.

Maximum honing:

0.02 mm (0.000787 in.)


NOTICE:

Excess honing will destroy the finished roundness.