Home › Engine / Hybrid System › 2KD-FTV ENGINE MECHANICAL › DRIVE BELT
RM1840EF _51 Engine / Hybrid System _009574 2KD-FTV ENGINE MECHANICAL _0052164 DRIVE BELT G

2KD-FTV ENGINE MECHANICAL  DRIVE BELT  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT FAN AND GENERATOR V BELT

a.
B000543

Check the belt for wear, cracks or other signs of damage.

If any of the following defects is found, replace the fan and generator V belt.

·

The belt is cracked.

·

The belt is worn out to the extent that the cords are exposed.

·

The belt has chunks missing from the ribs.



b.
B000540
0.563,0.313 0.729,0.51 0.167,0.198 10 false *a 2.24,0.313 2.406,0.479 0.167,0.167 10 false *b
*a CORRECT
*b INCORRECT


Check that the belt fits properly in the ribbed grooves.

HINT:

Check with your hand to confirm that the belt has not slipped out of the grooves on the bottom of the pulley. If it has slipped out, replace the fan and generator V belt. Install a new fan and generator V belt correctly.



c.
A271098
0.583,0.344 0.448,0.281 0.448,0.281 0.385,0.281 false 0.75,0.448 0.833,0.281 0.833,0.281 1.021,0.281 true 1.094,0.208 1.229,0.365 0.135,0.156 10 false A 0.24,0.198 0.375,0.354 0.135,0.156 10 false B

Check that the tensioner indicator mark is within range B shown in the illustration. If the mark is not within range B, replace the fan and generator V belt.

HINT:

If a new belt has been installed, check that the tensioner indicator mark is within range A.