Home › Engine / Hybrid System › 2KD-FTV ENGINE MECHANICAL › CYLINDER BLOCK(w/o DPF)
RM1840EF _51 Engine / Hybrid System _009574 2KD-FTV ENGINE MECHANICAL _0052174 CYLINDER BLOCK(w/o DPF) A

2KD-FTV ENGINE MECHANICAL  CYLINDER BLOCK(w/o DPF)  REPAIR  


PROCEDURE

Hide 1.BORE CYLINDER

HINT:
·

Bore all 4 cylinders for the O/S piston outside diameter.

·

Replace all the piston rings with ones to match the O/S pistons.



a.

Prepare 4 new O/S pistons.

Standard Piston Diameter:

92.42 to 92.45 mm (3.6386 to 3.6398 in.)



b.
A253394
2.177,2.792 1.729,2.406 1.729,2.406 1.635,2.406 true 2.271,2.813 2.708,2.427 2.708,2.427 2.802,2.427 true 1.979,1.01 1.979,1.979 true 2.25,3 2.74,2.74 2.74,2.74 2.823,2.74 true 1.5,0.719 1.219,0.469 1.219,0.469 1.125,0.469 false 2.219,0.896 2.708,0.635 2.708,0.635 2.792,0.635 true 2.885,2.667 3.083,2.844 0.198,0.177 10 false *3 2.792,1.625 2.979,1.802 0.188,0.177 10 false *4 2.792,3.729 2.979,3.906 0.188,0.177 10 false *4 1.458,2.281 1.625,2.458 0.167,0.177 10 false *1 2.844,2.333 3.063,2.5 0.219,0.167 10 false *2 0.948,0.354 1.115,0.531 0.167,0.177 10 false *1 0.115,0.063 0.313,0.24 0.198,0.177 10 false *A 0.115,2.25 0.313,2.427 0.198,0.177 10 false *B 1.896,2.01 2.115,2.177 0.219,0.167 10 false *2 2.833,0.563 3.031,0.74 0.198,0.177 10 false *3
*A w/o EGR Cooler
*B w/ EGR Cooler
*1 Size Mark
*2 Piston Pin Hole Inside Diameter Mark
*3 Front Mark (Arrow)
*4 Distance


Using a micrometer, measure the piston diameter according to the following conditions: 1) measure at a right angle to the piston center line, and 2) measure at the indicated distance from the piston head.

Distance:

65 mm (2.56 in.)



c.

Calculate how much each cylinder needs to be rebored.

Size to be rebored:

Size to be rebored = P + C - H

P = Piston diameter

C = Piston clearance: 0.07 to 0.09 mm (0.00276 to 0.00354 in.)

H = Allowance for honing: 0.02 mm (0.000787 in.) or less



d.

Bore and hone the cylinders to the calculated dimensions.

Maximum honing:

0.02 mm (0.000787 in.)


NOTICE:

Excess honing will destroy the finished roundness.