Home › Engine / Hybrid System › 2KD-FTV ENGINE MECHANICAL › TIMING BELT(w/ DPF) › from 2012.04
RM1840EF _51 Engine / Hybrid System _009574 2KD-FTV ENGINE MECHANICAL _0052176 TIMING BELT(w/ DPF) A

2KD-FTV ENGINE MECHANICAL  TIMING BELT(w/ DPF)  REMOVAL  


PROCEDURE

Hide 1.REMOVE NO. 1 ENGINE UNDER COVER

Hide 3.REMOVE RADIATOR HOSE INLET

Hide 5.REMOVE NO. 1 TIMING BELT COVER

a.
A015094

Remove the 6 bolts, 6 washers and timing belt cover.


Hide 6.REMOVE TIMING BELT

a.
A301857
0.479,1.167 0.844,1.167 true 0.833,1.448 0.688,1.448 0.688,1.448 0.688,1.167 true 3.01,1.188 3.01,0.99 3.01,0.99 3.219,0.99 true 3.094,1.208 3.094,1 true 0.302,1.104 0.49,1.292 0.188,0.188 10 true *1 3.208,0.896 3.427,1.094 0.219,0.198 10 true *1
*1 Timing Mark


Turn the crankshaft clockwise and align the timing marks as shown in the illustration.

HINT:

If reusing the timing belt, place matchmarks on the timing belt so that it can be installed exactly as before.



b.
A070550

Uniformly loosen and remove the 2 bolts and No. 1 timing belt tensioner.


c.

Remove the timing belt.

HINT:
A301858
2,0.333 2.26,0.542 0.26,0.208 10 false 90°

·

If turning the camshaft while the timing belt is removed, turn the crankshaft 90° counterclockwise as shown in the illustration.

·

When installing the timing belt, turn the camshaft to align the timing marks, and then turn the crankshaft clockwise to align the timing marks.




Hide 7.REMOVE NO. 1 TIMING BELT IDLER SUB-ASSEMBLY

NOTICE:

When inspecting the No. 1 timing belt idler, do not remove it unless absolutely necessary.


a.

Using a 10 mm hexagon wrench, remove the bolt, No. 1 timing belt idler and washer.