1.REMOVE INTAKE VALVE
Using SST, compress the compression spring and remove the 2 valve spring retainer locks.
Remove the spring retainer, compression spring, valve and spring seat.
Arrange the valves, compression springs, spring seats and spring retainers in the correct order.
2.REMOVE EXHAUST VALVE
Using SST, compress the compression spring and remove the 2 valve spring retainer locks.
Remove the spring retainer, compression spring, valve and spring seat.
Arrange the valves, compression springs, spring seats and spring retainers in the correct order.
3.REMOVE INTAKE VALVE STEM OIL SEAL
Using needle-nose pliers, remove the intake valve stem oil seal.
4.REMOVE EXHAUST VALVE STEM OIL SEAL
Using needle-nose pliers, remove the exhaust valve stem oil seal.
5.REMOVE SEMICIRCULAR PLUG
6.REMOVE NO. 1 STRAIGHT SCREW PLUG
If a No. 1 straight screw plug is corroded, replace it.
Using a 6 mm hexagon wrench, remove the No. 1 straight screw plugs.
7.REMOVE STUD BOLT
If a stud bolt is deformed or its threads are damaged, replace it.
Remove the stud bolts.