Home › Engine / Hybrid System › 2KD-FTV ENGINE MECHANICAL › CYLINDER BLOCK(w/ DPF) › from 2012.04
RM1840EF _51 Engine / Hybrid System _009574 2KD-FTV ENGINE MECHANICAL _0052182 CYLINDER BLOCK(w/ DPF) A

2KD-FTV ENGINE MECHANICAL  CYLINDER BLOCK(w/ DPF)  REPAIR  


PROCEDURE

Hide 1.BORE CYLINDER

HINT:
·

Bore all 4 cylinders for the O/S piston outside diameter.

·

Replace all the piston rings with ones to match the O/S pistons.



a.

Prepare 4 new O/S pistons.

Standard piston diameter:

92.42 to 92.45 mm (3.6386 to 3.6398 in.)



b.
A253957
2.208,0.354 1.573,0.125 1.573,0.125 1.375,0.125 false 2.333,0.375 2.802,0.125 2.802,0.125 2.896,0.125 false 2.281,0.604 1.885,1.573 1.885,1.573 1.885,1.698 true 1.792,1.708 1.99,1.885 0.198,0.177 10 false *3 2.844,1.302 3.031,1.479 0.188,0.177 10 false *4 1.177,0.052 1.396,0.229 0.219,0.177 10 false *1 2.917,0.052 3.135,0.219 0.219,0.167 10 false *2
*1 Size Mark
*2 Piston Pin Hole Inside Diameter Mark
*3 Front Mark (Arrow)
*4 Distance


Using a micrometer, measure the piston diameter according to the following conditions: 1) measure at a right angle to the piston center line, and 2) measure at the indicated distance from the piston head.

Distance:

63.5 mm (2.50 in.)



c.

Calculate how much each cylinder needs to be rebored:

Size to be rebored:

Size to be rebored = P + C - H

P = Piston diameter

C = Piston clearance: 0.07 to 0.09 mm (0.00276 to 0.00354 in.)

H = Allowance for honing: 0.02 mm (0.000787 in.) or less



d.

Bore and hone the cylinders to the calculated dimensions.

Maximum honing:

0.02 mm (0.000787 in.)


NOTICE:

Excess honing will destroy the finished roundness.