1.REMOVE NO. 1 ENGINE UNDER COVER
2.DRAIN ENGINE COOLANT
3.DISCONNECT RADIATOR HOSE INLET
4.REMOVE FAN SHROUD
5.REMOVE CRANKSHAFT PULLEY
6.REMOVE FRONT CRANKSHAFT OIL SEAL
| *1 | Protective Tape |
Using a screwdriver, pry out the oil seal.
Do not damage the surface of the oil seal press fit hole or the crankshaft.
Check the crankshaft for damage after removing the oil seal. If the crankshaft is damaged, smooth the surface with 400-grit sandpaper.
Tape the screwdriver tip before use.