Home › Engine / Hybrid System › 2TR-FE ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL › 2011.10–2012.04
RM1840EF _51 Engine / Hybrid System _009575 2TR-FE ENGINE MECHANICAL _0052188 REAR CRANKSHAFT OIL SEAL A

2TR-FE ENGINE MECHANICAL  REAR CRANKSHAFT OIL SEAL  REMOVAL  


PROCEDURE

Hide 2.REMOVE CLUTCH COVER ASSEMBLY

Hide 3.REMOVE CLUTCH DISC ASSEMBLY

Hide 4.REMOVE FLYWHEEL SUB-ASSEMBLY

a.
A099210
0.885,1.427 0.667,1.583 0.667,1.583 1.219,1.708 false 0.271,1.51 0.75,1.708 0.479,0.198 10 false SST

Using SST, hold the crankshaft.

SST
09213-54015  (91651-60855)
09330-00021  


b.
A252562

Remove the 10 bolts and flywheel.


Hide 5.REMOVE REAR CRANKSHAFT OIL SEAL

a.
A252564
1.052,1.948 0.938,1.948 0.938,1.948 0.688,1.573 true 1.74,1.146 2.427,1.948 2.427,1.948 2.552,1.948 true 1.083,1.854 1.271,2.021 0.188,0.167 10 false *1 2.625,1.844 2.813,2.01 0.188,0.167 10 true *2
*1 Cut Position
*2 Protective Tape


Using a knife, cut off the lip of the oil seal.


b.

Using a screwdriver, pry out the oil seal.

NOTICE:
·

Do not damage the surface of the oil seal press fit hole or the crankshaft.

·

After removing the oil seal, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.



HINT:

Tape the screwdriver tip before use.