Home › Engine / Hybrid System › 1GR-FE ENGINE MECHANICAL › DRIVE BELT › from 2012.04
RM1840EF _51 Engine / Hybrid System _009577 1GR-FE ENGINE MECHANICAL _0052204 DRIVE BELT A

1GR-FE ENGINE MECHANICAL  DRIVE BELT  INSTALLATION  


PROCEDURE

Hide 1.INSTALL FAN AND GENERATOR V BELT

a.
A225650
2.594,1.021 2.333,1.021 false 0.302,0.76 0.49,0.948 0.188,0.188 10 false *1 1.427,0.729 1.615,0.917 0.188,0.188 10 false *2 0.865,1.094 1.052,1.281 0.188,0.188 10 false *3 2.333,0.531 2.521,0.719 0.188,0.188 10 false *3 3.104,0.635 3.292,0.823 0.188,0.188 10 false *4 2.875,1.5 3.063,1.688 0.188,0.188 10 false *5 2.208,1.594 2.396,1.781 0.188,0.188 10 false *6 1.427,1.469 1.615,1.656 0.188,0.188 10 false *7 2.635,0.927 2.823,1.115 0.188,0.188 10 false *8
*1 Vane Pump
*2 Water Pump
*3 No. 2 Idler
*4 Generator
*5 Cooler Compressor
*6 No. 1 Idler
*7 Crankshaft
*8 V-ribbed Belt Tensioner


Set the fan and generator V belt onto each part.


b.

While turning the belt tensioner counterclockwise, remove the pin.

NOTICE:

Make sure that the fan and generator V belt is properly installed to each pulley.



c.

Check that the belt fits properly in the ribbed grooves.

HINT:

Make sure to check by hand that the belt has not slipped out of the grooves on the bottom of the pulley.