Home › Engine / Hybrid System › 1GR-FE ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL › from 2012.04
RM1840EF _51 Engine / Hybrid System _009577 1GR-FE ENGINE MECHANICAL _0052209 REAR CRANKSHAFT OIL SEAL A

1GR-FE ENGINE MECHANICAL  REAR CRANKSHAFT OIL SEAL  REMOVAL  


PROCEDURE

Hide 2.REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY

A302004
1.948,0.74 2.469,0.74 2.469,0.74 2.469,1.521 true 0.938,1.51 2.677,1.521 true 2.74,1.427 3.042,1.594 0.302,0.167 10 true SST

a.

Using SST, hold the crankshaft.

SST
09213-54015  (91651-60855)
09330-00021  


b.
A076327

Remove the 8 bolts, rear spacer, drive plate and ring gear and front spacer.

NOTICE:

Do not reuse the bolts.



Hide 3.REMOVE REAR CRANKSHAFT OIL SEAL

a.
A302005
0.75,1.594 0.156,0.302 0.156,0.302 0.313,0.302 true 1.677,1.146 1.302,0.25 1.302,0.25 1.104,0.25 true 0.354,0.188 0.667,0.385 0.313,0.198 10 false *1 0.917,0.146 1.229,0.344 0.313,0.198 10 false *2
*1 Cut Position
*2 Protective Tape


Using a knife, cut off the lip of the rear crankshaft oil seal.


b.

Using a screwdriver, pry out the rear crankshaft oil seal.

NOTICE:

Do not damage the surface of the oil seal press fit hole or crankshaft.


HINT:

Tape the screwdriver tip before use.