1.REMOVE VALVE
| *1 | Wooden Block |
Using SST and wooden blocks, compress and remove the valve retainer locks.
Arrange the removed parts in the correct order.
Remove the retainer, valve spring and valve.
Arrange the removed parts in the correct order.
2.REMOVE VALVE SPRING SEAT
Using compressed air and a magnet hand, remove the valve spring seats by blowing air onto them.
3.REMOVE VALVE STEM OIL SEAL
Using needle-nose pliers, remove the valve stem oil seals.
4.REMOVE NO. 1 STRAIGHT SCREW PLUG
| *A | for Bank 1 |
| *B | for Bank 2 |
If coolant leaks from a straight screw plug or a plug is corroded, replace it.
Using a 10 mm hexagon wrench, remove the 4 No. 1 straight screw plugs and 4 gaskets.
5.REMOVE NO. 2 STRAIGHT SCREW PLUG
| *A | for Bank 1 |
| *B | for Bank 2 |
If coolant leaks from a straight screw plug or a plug is corroded, replace it.
Using a 14 mm hexagon wrench, remove the 2 No. 2 straight screw plugs and 2 gaskets.
6.REMOVE STUD BOLT
If a stud bolt is deformed or its threads are damaged, replace it.