Home › Engine / Hybrid System › 1GR-FE ENGINE MECHANICAL › CYLINDER HEAD › from 2012.04
RM1840EF _51 Engine / Hybrid System _009577 1GR-FE ENGINE MECHANICAL _0052212 CYLINDER HEAD A

1GR-FE ENGINE MECHANICAL  CYLINDER HEAD  REPAIR  


PROCEDURE

Hide 1.REPAIR INTAKE VALVE SEAT

NOTICE:
·

Repair the intake valve seat while checking the seating position.

·

Keep the lip free of foreign matter.

·

Take off the cutter gradually to make the intake valve seat smooth.



a.
A127139

Using a 45° cutter, resurface the valve seat so that the valve seat width is more than the specification.


b.
A277104
2.531,0.167 2.99,0.365 0.458,0.198 10 60° 2.802,0.313 3.26,0.51 0.458,0.198 10 45° 3.052,0.469 3.406,0.667 0.354,0.198 10 30° 2.635,1.604 2.948,1.802 0.313,0.198 10 *1
*1 Width


Using 30° and 60° cutters, correct the valve seat so that the intake valve contacts the entire circumference of the seat. The contact should be in the center of the intake valve seat, and the intake valve seat width should be maintained within the specified range around the entire circumference of the intake valve seat.

Standard width:

1.0 to 1.4 mm (0.0394 to 0.0551 in.)



c.

Hand-lap the intake valve and intake valve seat with an abrasive compound.


d.

Check the intake valve seating position.


Hide 2.REPAIR EXHAUST VALVE SEAT

NOTICE:
·

Repair the seat while checking the seating position.

·

Keep the lip free of foreign matter.

·

Take off the cutter gradually to make the exhaust valve seat smooth.



a.
A127140

Using a 45° cutter, resurface the valve seat so that the valve seat width is more than the specification.


b.
A124255
2.573,0 2.813,0.156 0.24,0.156 10 false 75° 2.938,0.115 3.177,0.271 0.24,0.156 10 false 45° 3.156,0.385 3.396,0.542 0.24,0.156 10 false 30° 2.792,1.802 3,2 0.208,0.198 10 false *1
*1 Width


Using 30° and 75° cutters, correct the exhaust valve seat so that the exhaust valve contacts the entire circumference of the seat. The contact should be in the center of the exhaust valve seat, and the exhaust valve seat width should be maintained within the specified range around the entire circumference of the exhaust valve seat.

Standard width:

1.0 to 1.4 mm (0.0394 to 0.0551 in.)



c.

Hand-lap the exhaust valve and exhaust valve seat with an abrasive compound.


d.

Check the exhaust valve seating position.