Home › Engine / Hybrid System › 2KD-FTV FUEL › FUEL SUPPLY PUMP(w/o DPF)
RM1840EF _51 Engine / Hybrid System _009578 2KD-FTV FUEL _0052216 FUEL SUPPLY PUMP(w/o DPF) G

2KD-FTV FUEL  FUEL SUPPLY PUMP(w/o DPF)  INSPECTION  


PROCEDURE

Hide 1.INSPECT FUEL SUPPLY PUMP ASSEMBLY

a.
A191340
1.24,0.51 1.365,0.51 1.365,0.51 1.563,1.156 true 0.99,1.49 1.125,1.49 1.125,1.49 1.677,1.25 true 0.979,1.854 1.115,1.854 1.115,1.854 1.708,1.292 true 0.865,1.406 0.979,1.552 0.115,0.146 10 false 2 0.833,1.76 0.948,1.906 0.115,0.146 10 false 1 1.021,0.427 1.208,0.583 0.188,0.156 10 false *1
*1 Suction Control Valve


Inspect the suction control valve.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 1.9 to 2.3 Ω


If the result is not specified, replace the fuel supply pump assembly.



b.
A231754
1.531,1.469 2.135,1.469 true 1.531,1.521 2.031,1.802 2.031,1.802 2.135,1.802 true 1.958,0.198 1.844,0.198 1.844,0.198 1.531,1.365 true 2.188,1.375 2.313,1.521 0.125,0.146 10 false 2 2.188,1.708 2.313,1.854 0.125,0.146 10 false 1 2.021,0.083 2.208,0.24 0.188,0.156 10 false *1
*1 Fuel Temperature Sensor


Inspect the fuel temperature sensor.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 2.32 to 2.59 kΩ


If the result is not specified, replace the fuel supply pump assembly.