Home › Engine / Hybrid System › 2KD-FTV FUEL › FUEL FILTER › from 2012.04
RM1840EF _51 Engine / Hybrid System _009578 2KD-FTV FUEL _0052218 FUEL FILTER A

2KD-FTV FUEL  FUEL FILTER  REPLACEMENT  


CAUTION / NOTICE / HINT

HINT:

When replacing the filter, use TOYOTA genuine parts or equivalent parts.


PROCEDURE

Hide 1.REMOVE FUEL FILTER ELEMENT ASSEMBLY

HINT:

Replacement of the fuel filter element can be performed with the fuel filter installed to the bracket.


a.
A098900

Disconnect the clogging switch connector.


b.

Move the clip to disconnect the hose connected to the filter inlet.


c.

Connect a hose to the drain cock. Place the other side of the same hose into a container.


d.

Loosen the drain cock to drain fuel (approximately 50 cc (3.0 cu. in.)).


e.

Tighten the drain cock.


f.
A098901

Using a screwdriver as a lever, loosen the fastener nut until it can be loosened by hand.


g.
A098907

Fully loosen the fastener nut by hand.


h.
A098902

To remove the cap, pull up one side of the cap, and then lift it off.


i.

Remove the fuel filter element from the case.


j.

Remove the case O-ring.


Hide 2.INSTALL FUEL FILTER ELEMENT ASSEMBLY

a.
A098903

Attach 2 new O-rings to a new fuel filter element and a new O-ring to the case.


b.

Install the fuel filter element to the case.


c.
A098904

Align the mark on the cap and the mark on the case.


d.
A301781
2.802,3.625 2.958,3.823 0.156,0.198 10 false A

Push the cap onto the case by hand.

Standard clearance (A):

1.5 mm (0.0590 in.) or less


HINT:

The clearance between the cap and case should be even around the entire circumference of the cap and case.



e.
A302649
1.448,4.302 1.604,4.5 0.156,0.198 10 false A 3.094,3.375 3.25,3.573 0.156,0.198 10 false B

Turn the fastener nut until a "click" sound is heard.

HINT:

Just before the marks of the case and nut align, the fastener nut will become more difficult to turn. Use a screwdriver as a lever to turn the fastener nut.



f.

Measure the distance between the marks on the cap and case, and the clearance between the cap and case.

Standard distance (A):

1.0 mm (0.0393 in.) or more


Standard clearance (B):

1.0 mm (0.0393 in.) or less



g.
A220698

Connect the hose to the filter inlet and install the clip as shown in the illustration.


Hide 3.RESET FUEL SYSTEM WARNING LIGHT

a.

Turn the ignition switch to ON.


b.
A302650

After turning the ignition switch to ON, connect the clogging switch connector no sooner than 3 seconds have passed but no later than 60 seconds have passed.


c.

Check that the combination meter's fuel system warning light turns off.